pm6

[not to bright!!!]

my pm6 isnt working properly can anyone help it is chopping balls i deffo no that the eyes work and the board works also im using hp air. i was using really fragile paint and it was breaking paint like mad then i put some harder stuff and was fne but then again sum paint that was abit softer chopped. HELP

 

[Dusty]

check your detents? operating pressure too high?

 

[speedbird_666]

Lower the LPR pressure by turning it Clockwise a turn or two (full 360deg, looking from the front of the gun).

If you get dropoff during rapid fire after lowering the pressure, raise the LPR pressure a little (Counter clockwise from the front).

Make sure you use something like DOW33 when lubing the bolt after lowering the LPR pressure, rather than the dye crap they ship with the guns.