PM6 air leak

[chrisplod]

Hey guys,

Ive got a pm6 - and had a few air leaks from the bolt and the trigger area - replaced all the o-rings, but for some reason there is a massive air leak from the bolt area inside the breach/ where the eyes are.
Also the bolt itself seems to stick in the sleave.

Ive lubed the body and the bolt/sleave but still it gets stuck.... Have tried the original fuse bolt and a Orange SAM bolt, but still no joy

Any ideas greatly appriciated!

chris

 

[MJ]

have you lined up the airport properly?

try and cycle a few shots aswell see if it seals the new orings.

if its from the frome above the trigger then its possibly you solenoid

-MJ

 

[Scars]

Matrixs have this nasty tendancy of doing this

I found this guide very useful that gassy put up when i had a problem

http://www.pbnation.com/showthread.php?t=1623383

I found it to be my bolt sail o-ring and the 2nd and 3rd Oring buggered. my problem was i was using Old Orings, make sure your using new ones as its unbeleivevable how much crap geting in your toolbox/kitbag

worst case give Ash at Dye a call. Repairs are normally incredibly reasonable

 

[boca]

sounds like you have used incorrect sized o rings
change top tip oring 014, beer can internal 017 tophat internals 017 and 013. that should sort any air leaks down barrel.
if leaking down selonoid still,change bolt sail 015 ,outer sleeves 020. also check your lpr and hpr are set, these being to low can cause leaks from seloniod,other than that the only other reason for selonoid leaking is if the seal has gone on it

 

[chrisplod]

cheers peeps ill give it a go!