please help! timmy probs!

[danny5497]

hi all who read this. i just purchased a second hand naughty dogz timmy, the bollox i think but thats my view. anyways, im running it off an angel air at 500psi set at low pressure but the thing is the markers gauge is reading 50-60 psi and it doesnt shoot very far, i cant seem to raise the markers pressure above 50-60 psi and im very new to the timmy so not sure how to do it unless directed.
please help me out guys,
all help appreciated,
danny.

 

[Raxxman]

its the two regs

the torpedo is the HP reg, and the LPR is just above it.

use an alan key into the LPR (its forward facing just below the barrel) to turn the LPR up to 60-70 psi

Then to change velocity use the torpedo reg, the alan key port is located on the underside of the reg.

 

[danny5497]

cheers but ive tried turning thr lpr and it makes no difference at all

 

[Scars]

Dan

Dial both regs out.... then slowly dial the inline reg (the one you hold) inward a Few Turns till you hear the gas flo in - then add a quarter turn

then adjust the LPR (the long thing on front) til it reaches 70-80 - once your LPR is dialed to 70-80, dial your inline reg upward... you'll hear it shooting higher, the LPR ensures it doesnt go over 70-80 psi on your guage

 

[danny5497]

CHEERS IAN

cheers mate, your a top man. all sorted now.

 

[Gyroscope]

That gauge is for the LPR, like folks are saying. They are getti g something wrong though.

The air from the LPR is only used to make the bolt and ram go forward and backward. The air from the inline is what is released to push paint down the barrel.

 

[PaintballBudgie]

Uncle Bobs finest joke. Gets em every time.