PCB prob

[Dskize]

can anyone tell me what these crimps are called and any ideas where to get them (id rather not send the marker on in case anyone suggests that)

also if there is a crimping tool available that doesnt cost £200

cheers

BTW there bigger than the ones used on angel boards

 

[John C]

They look like JST connectors if so then you should ask your favorite board tech john@spitfirepaintball.co.uk


The crimping tool doesnt cost £200. Its at least 20 times that figure, and the size of your living room....

 

[Dskize]

funny that - I was aming this question at you

RS components ? i tried no nick a pre-crimped one off one of your intelifeed connectors but it was to small for the housing

 

[John C]

They do fit, but once the housing is even slightly worn out they come right out.
They are the only ones you can buy from RS, they are actually molex precrimps.


But I do have one or two proper JST precrimps that I salvaged.

Email me your address and Ill send them on...

(I assume you want them as short as possible?)

John

 

[Dskize]

yeh i think so - adress on way