Output pressure to go into Center flag reg

[nickp]

Guys


Can anyone tell me a good output pressure from an armageddon, which is to feed a center flag reg, to feed a Matrix,

I know that the center flag shouldn't be putting more than about 220psi into the marker ( is that Figure right???) any help is appreciated..

 

[Beaker]

a good rule of thumb is that your air system output should be about 200-250psi higher than your inline reg.

That give enough pressure difference for the reg to work properly.

So if your inline (Centreflag) output is about 200psi I would set your armie about 400-450.

 

[nickp]

Cheers Beaker...

Hows the barrel????

 

[Mr_Toads_Wild_Ride]

My maxflow feeds my bee hive reg on my matrix at about 450 psi and i dont suffer any drop off!

Instructions mention you shouldnt feed any more then 160 psi in to your solonoids

 

[nickp]

so I need to make sure mt centerflag reg is outputting at about 150 -160psi then, coll... can anyone tell me how I know the output on the CF reg???

 

[Beaker]

Nick

Barrel is cool - goes well with the all black Timmy

As for your reg, just turn it right down then turn it back up and go by velocity more than output pressure. I doubt you'll blow the solenoid unless you chrono at 380 or something

you can then check it by putting it into any ASA with a guage port.