old Automag prob

[pegleg]

Hi i have an old AutoMag 68 and it has started to leak on the front for grip so i changed the seals and it did not help so i swapped the spring pack thing for the one in the air valve at the back of the gun and it started to leak there instead so i know its the spring thing. does any one know what the thing is called and where i can get one in the uk or how to fix it as it has no seals on it
Thanks
only a second gun so dont lol,Noah signed it him self you know.

 

[ying]

any help to you

try here for fixing your mag and use the tec support section http://www.airgun.com/. it may be the on /off valve seals leaking ,both the inner and outer or the pin ( chrome plating coming off ). the back leak may be the pressure / adusting screew is in to far try turning it back slighty, or valve pin seal. i hope this help a bit.

 

[Sajj101]

FatBob deals with anything AGD in the UK, try them.
http://www.fatbobspaintball.co.uk/acatalog/AGD_Parts_and_Accessories.html

 

[jester22]

try here.

http://www.automagsuk.com/

 

[Skeet]

I am assuming it is running on air.

Do you have some sort of reg on the fore grip then?

You don't actually need to double reg a mag.

Just set 850 or whatever coming from your bottle and dial the main reg on the back of the gun for velocity.

 

[pegleg]

yes it has an adjuster for the pressure on the for grip so i put a pressure gage on it and set it to 750psi like it said on a website I only use it a few time and it was ok, its only been on air and only leaks when the pressure is above 350psi but i used to use it on 750psi ,but now i have put the spring pack in the main valve it leaks out the rear of the gun through the alan key hole where air would come out if it was overpressurised. if i put the pressure down so it does not leak the balls come out at about 120 fps

 

[Skeet]

Well...you don't say what type of mag it is, or anything...but you don't need the AA reg that you have on the front.

You can just run from the bottom line to the reg at the back of the gun.

Tell us a bit more about the setup you have...pics are good too!