NT trigger

[Gonzo47]

Have little problem with trigger.

Looks like 2 bolts which are holding trigger when you adjust an angle don't work properly. After 1-2 rounds trigger goes to "bottom" position.

Any ideas? Maybe you can recommend a trigger for replacement?

Thanks

g.

 

[soul snatcher24]

if you mean the two small black set screws at the top on the front of the trigger then a small drop of blue lock tight should hold them in place fine, or ever a tiny piece of PTFE tape will do the job

however make sure that both of them are done up tight otherwise the trigger will not hold in one position

hope this helps
Ryan, team domination

 

[Gonzo47]

yep those two small blacks.
ok wil try to do so. Got training this weekend.

Thanks

 

[Gonzo47]

do i need to take UL frame off to take- change trigger?

 

[soul snatcher24]

it does make it easier to get to the trigger adjustments or to remove the trigger, but remember to disconnect the eye and solenoid wires from the board first

did the locktight work?

 

[frenchy2475]

Pretty sure you can't get aftermarket triggers for the NT as the frame Is different to the DMs.

Although I know Critical are bringing one out very soon and they are
amazing.