Not sure if its possible but

[Revolt]

Any way to adjust stock ion trigger so you only really have to tap the trigger so it fires? just now i have it set about 0.8mm from the back, and use a strange walking stlye instead of putting the ends of my fingers flat across teh trigger and doing alternative taps i put the very tip on the edge of the trigger and bend my fingers, which i can do about 8bps but then i have the small matter of my whole hand sticking out like a big target :/

so if i could make the trigger be really close to the back and just have to nudge it to fire i think it would help me, would i have to take the trigger magnet out orrrrrrr just tighten it lots? thanks in advance;/ and sorry if its already been posted

 

[ollgeeze]

you cant fine tune a stock ion trigger, basicaly cus theyr crap... lol loads of sideplay doesnt help and the fact that you cant actually adjust the magnet intensity doesnt help either. you'l find the stock trigger will bounce like crazy if you set it too short, you cant adjust the microswitch activation point either so you wont be able to have the trigger as far back as you want it. also if you remove the magnet your trigger return speed will limmit your rate of fire and increase the bouncing.

if you want full adjustment you need to buy an aftermarket trigger with full adjustment like the ones im selling you can set these right back... or right forwards.

 

[Bob]

MY mates ions have pretty well setup stock triggers, one of them did however them buy an ollgeeze^ trigger.

Think they did it by taking the trigger out and screwing the grub screw further in then putting the trigger back in, can't remeber exactly but made the stock trigger much nicer.

 

[ollgeeze]

yeh but what the man wants is his trigger right back in the frame but its impossible with the stock trigger because the microswitch point restricts this since its not adjustable.... unless he hacks away at it with a file lol.