New loader, need help!

[p8krazy]

Whatsup guys. I just got a Halo TSA LCD and I need some help with setting it up. Its got motor duration, timeout, and sensitivity threshold. I don't know what those mean so I need to know what they are and a little advice on how to set them. Any kind of advice would be greatly appreciated.

 

[JoeJr]

hey mate i got one too...motor duration is the lenght of the spin time 15 is the longest and 3 is the shortest.....timeout is...well i dont have a clue but in the manual it says..... ' a low number is reccomended for markers of high rate of fire'........' a higher number is reccomended for markers with lower shot counts"......sensivity threshold is how sensitive it is to sound the lower the number the more sensitive its going to be i hope i helpd

 

[section 8]

i would say that 'timeout' would mean, logically, the amount of time that it takes for the motor or electro parts to go on some sort of standby system... thus when it means 'a low timeout setting is needed for markers with higher rates of fire' then due to the higher ROF the timeout has to be low so that the hopper can keep up!

hope this helps
Scott B

 

[Rosie]

What marker you got bud? if you've got a lower end marker (I guess you have), then make the hopper slower.

Are you sure you have to set it?
Aren't there factory settings on there?

Use it as it is, & see if there are any problems with it; then change it.

If you start chopping paint- it might be too fast.
But then conversely it must be fastest enough so your marker doesn't keep missing shots. This may also cause it to chop.

Try it, & tell us how it goes- we will help you change it if you see any problems.