I have a Tippmann model 98 custom and when fireing it the balls go some distance and then turn a bit what can I do to fix this will a expansion chamber fix it?
Need some help
- Thread starter Mac1011
- Start date
well what barrel are you using???, that will have a big impact on it. then what paint, then your velocity.
an exp chamber will help stop liquid CO2 getting into the gun and causing velocit spikes and general messing up of internals.
answer the above points then well see
an exp chamber will help stop liquid CO2 getting into the gun and causing velocit spikes and general messing up of internals.
answer the above points then well see
.
a 32 degrees whisper aluminum barrel with holes it came free when I got my gun
and the paint is brass eagle mixed with32 degree balls
a 32 degrees whisper aluminum barrel with holes it came free when I got my gun
and the paint is brass eagle mixed with32 degree balls
well if the balls are old and have been sitting for a while then there may be dimples in the shell of the fill may have settled on one side. both ov which would cause them to swerve.
check inside the barrel to see if its clean.....................and err..............it wasnt windy was it????
check inside the barrel to see if its clean.....................and err..............it wasnt windy was it????
thanks
I knew I should have just got the expensive balls
the barrel was clean and there was zero wind then so it was the balls then I was scared my gun wasnt working right
Thanks alot for your help
I knew I should have just got the expensive balls
the barrel was clean and there was zero wind then so it was the balls then I was scared my gun wasnt working right
Thanks alot for your help
if ur looking for range and accuracy then chech out the flat line.........i know its but ugly but it works.