MODS PLS DELETE, thanks

[J@mes]

lo there,

I need to know how to get rid of bounce, at stargate my ion was bouncing like mad after i installed my NDZ blade trigger, i didnt have the time there and then to get rid of it.

So i need someone to point me in the right direction.
Is it to do with my trigger setup (pretty light pull and very short and when you give the tank a good slap, it fire's) .

thanks guys

-james

 

[Lovetone]

raise your debounce settings on your board if it has them

or make your pull longer and heavier.

 

[J@mes]

would a stock ion board have a debounce setting?

-james

 

[Dark Stranger]

www.smartparts.com

That should tell you!

 

[Revolt]

no it doesnt... just make the pull a bit stronger, and lengthen it so it has to travel further before it activates the microswitch

 

[lemonadeX]

Got the same trigger as James - I'm just wondering which screw adjusts the whole trigger pull? (not the screw which actually presses into the microswitch).

Cheers,

-Will

 

[J@mes]

you got me there, i dont know what the upper screw is for.

and does it come with two magnets, or just one?

-james

 

[J@mes]

fuger, it comes with two, but i can only see the one below the screw that hits the microswitch

-james

 

[J@mes]

anyone? is there a magnet above and below the pin that hits the micorswitch??

please i need a response

-james

 

[Fish]

nope, dont think so mate... not from looking at mine at least