Mini drop off problem

[Maddogwhitey]

Ive got an invert mini of which im having drop off isues with. its a gen 2 mini with a virtue board in it. makrers seems to drop off a full 100psi on the gauge when it hits about 8 to 10 bps.

internals are stock. lookingt geting the derlin bolt. will this solve the issue.

 

[Bolter]

I doubt the bolt will solve any issue.

Id ask your settings, but it seems you have upgraded and I dont know the new board.

Have you tried putting the old board back in? If it works fine with the old board then I would say your settings need changing on the new board.

Also check you have screwed the bottle all the way in. Even a small turn not in, can cause problems.

 

[Maddogwhitey]

tried the stock board strripped and cleaned it..and now it leaks down the barrel..YEAYY ME!

 

[RainbowShooter]

100psi?

 

[Maddogwhitey]

gauge on the side goes from 200 mto 100 psi

 

[RainbowShooter]

It may sound stupid, but is the bottle in fully, if so try unscrewing 1/4 a turn or so. If it is your problem that you need to unscrew the bottle a little bit, try placing a standard bottle oring in the airport.

 

[Skeet]

Also bear in mind, that Virtue boards, commonly need a Higher Dwell setting than your stock board...not because it NEEDS higher dwell, but reads it differently.

Try upping your dwell after fixing the leak that wasn't there before you tried to fix it.

Oh, new battery is obligatory.

 

[Maddogwhitey]

cheers skeet. leak now fixed.

will try the other thing now

 

[Skeet]

No worries...try battery first.

Pop a fluffy in the barrel then get it going, then get it ramping, you will hear the difference if it is shooting down.

If it still is, up the dwell a couple of points, and if that works, set it properly next time your near a chrono as obviously, your Velocity will have also increased.

 

[Jimmymac]

Ive got an invert mini of which im having drop off isues with. its a gen 2 mini with a virtue board in it. makrers seems to drop off a full 100psi on the gauge when it hits about 8 to 10 bps.

internals are stock. lookingt geting the derlin bolt. will this solve the issue.

put board back to factory and go from there