max flow inline

[Potter Loki]

hey gents got a maxflow inline on my shocker and the consistancy hasent been that great,saying that the paint was very small and the bore on my freak was .684(smallest i got)im wondering should i ditch the inline and just get a preset tank and on/off or what?
cheers

 

[Bob]

hey gents got a maxflow inline on my shocker and the consistancy hasent been that great,saying that the paint was very small and the bore on my freak was .684(smallest i got)im wondering should i ditch the inline and just get a preset tank and on/off or what?
cheers

Would be worth checking a few things first bud.

Make sure your reg is clean and that its been lubed properly.

The bolt o-rings, bolt guide etc are in good nic and lubed.

Check your detents, the springs can rust and cause problems with the balls passing them.

Check the SFT o-rings in good nic at the front of the breach

Check your dwell is not set too low.

May be stuff you've already checked hope ya get it sorted

 

[Potter Loki]

thanks for the advice mate, yeah was all checked over, i got a feeling it was the paint which had a very small bore, it wernt shooting that accurate either but that should be cured soon! it isnt going to be shot till the end of april ish now so will see how it is
cheers