max-flo on e-blade?

[chris h]

I am currently running my max-flo (newish model!) on a freak voodoo impulse at approx 180psi input ......

i understand the input on an e-blade is between 500-600psi input

....is it as simple as transferring the air system and cranking the pressure up.....or do i need to alter anything on the max-flo e.g. spring.

Not too sure if there are "low pressure and high pressure" max-flos.

Basically....is it simple or is it a bar-steward!!!!

All help gratefully received......TA

Chris H

 

[Shep]

yes there are lp & hp maxflows, but am unsure as to what is needed to make a lp one a hp one.yours on the imp will be lp

 

[chris h]

ta

thanks 4 that....its a start...

 

[Skeet]

just a new spring and maybe piston..as much as i hate to say it, speak to smart parts..or buy my HP maxflow!

 

[Longbow]

i have got a Low pressure Max-flow on my e-blade, i have had to turn the pressure all the way up (about 300psi) on it. But it works fine

 

[Skeet]

You need a minimum of 550 to 600 psi really on a cocker, especially an eblade, otherwise you will strve it of air when rapid firing...input preassure from inline reg will be around 325 psi, ut should ideally be sweetspotted.

 

[fatbeerboy]

how can you tell the difference between lp and hp. i have a maxflo on an eblade i have just bought the gague goes up to 700psi but when you turn it up it farts! and gass escape's any ideas?


p.s. sorry about thread jacking

 

[jahlad]

actually the input pressure to the marker is prob around the 300 mark as your inline reg will bring the pressure down.....i was running the turtle at around 280 off my conquest with a gas thru grip instead of an inline and it worked perfectly.....its a case of try it and see.
generally most people use the hp maxy with cockers but there is no reason it can work....might need to swap your valve for a lower pressure one tho....eg the supercharger (£10 in planets sale section) or fiddle with the marker set up a little

 

[Skeet]

£10 for a supercharger...? Has something better come out then?

 

[stark]

Originally posted by fatbeerboy
how can you tell the difference between lp and hp. i have a maxflo on an eblade i have just bought the gague goes up to 700psi but when you turn it up it farts! and gass escape's any ideas?

The LP MaxFlow has a pressure relief valve on it - that is whats 'farting' when you turn it up. Its set to around 300PSI AFAIK.