matrix help

[Loki *Uk*]

okay finally got my matrix working but have a few questions probbaly fairly simple ones for Ronnie, g and the Tigers but wanna know and figure out how to sort any queries for future.

1) My matrix seems to bleed air continuously, sounds like from the rear, but aint sure. I have read this is natural, can anyone clarify.

2) I occasionally get a ball stuck in the breech, the bolt willnot move so I guess the pressure is very low and it wont chop it. Now so far the only way I have solved this is buy using a squuegie and getting shot in the palm of my hand...Now guys any solutions.

3) I also wanna get a a twister feed neck (easier to swap between my egg and my halo). I know Sykes told me where to get them from but have deleted the PM, so help would be appreciated.

4) any other hints and tips about the Matrix LCD,


Cheers all

 

[jahlad]

i dont know much about matrix but i wouldnt bother with a twist feed neck they are impossible to fasten by hand.,....get one that uses an allen key to tighted it such as the ccm ones.....ask com on here he got me mine

 

[booga]

A slight leak from the rear of the marker is definatly not natural, if you can narrow it down to a specific area where the leak is coming from it would be easier to identifiy, chances are it's one of the back 'plugs' that just needs tightening.
If your bolt is boucing off the odd ball or two chances are you have your LPR set a wee bit too low, the bolt hasn't enough pressure to push the ball forwards! Try turning up the LPR 1/4 turn, sounds like it's nearly set just right just a little bit too low.

 

[Loki *Uk*]

Originally posted by booga
Try turning up the LPR 1/4 turn, sounds like it's nearly set just right just a little bit too low.

Okay mate is that left or right as you look towards the marker?

 

[booga]

That should be turning it to the right although I'm not 100% sure all LPR's adjust the same, although if it's set just on the edge of being OK turning it the wrong way would stop the bolt cycling properly so it would just be a matter of turning it back to where you started and then back another 1/4 turn.

 

[Loki *Uk*]

Cheers mate,

will check this weekend where the leak is coming from.

 

[sykesg]

loki

If you get an eye fitted then the bolt will never close on a half fed ball and you can run the bolt pressure as low as you like.

Matrix live and breath on their o rings the only problems I've ever come across on stock bolts have been leaky o rings - grease em if it still leaks change em. Make sure the pressure into the gun is good though as a faulty reg will obviously blow out the best kept bolt.

Speak to roughneck or here in england draxxus europe you can get a low rise, high rise, fit any hopper feed neck

let me know how it goes

 

[Hudson']

i dont know much about matrix but i wouldnt bother with a twist feed neck they are impossible to fasten by hand.,....get one that uses an allen key to tighted it such as the ccm ones.....ask com on here he got me mine

Changed my name lol ^^