Lucky Timmy B Un1 Board problem

[sumo89]

iv got a lucky un1board for my gen 3 timmy and the hole for the screw to attach it to the frame seems off centre, and if i move the board so the hole lines up then the switches dont reach outside of the trigger frame so would be impossible to press and the microswitch gets caught on a bit of the frame

is there an online manual or anything of how to install it in my timmy?
or could someone from lucky explain it to me?

id take a picture but i dont have the cable for my camera in this country.

if it helps on the board it says v13 and on the case it says TIM-001

 

[Dark Stranger]

PM Lucky_Tech.

Or if you feel comfortable doing it either widen the existing holes with a small drill bit or drill some new holes. (Without damaging the copper tracks on the pcb!)

 

[sumo89]

i was going to do that, but the board isnt quite big enough so it doesnt reach the screw hole if the microswitch and the buttons are to set properly.

Does lucky_tech work for lucky then?