Level 10

[FADEAWAYRAY]

Well I'm now putting my new level 10 bolt in my minimag rt, but can't figure out how to get it working right.

*What's Happening
-When I shoot it make a psst sound and can't push a paintball past the nubbin.
-It doesn't leak out air until i shoot.
-I am using the small bolt mainspring, 1.5 carrier, and 2 shims

Any ideas on whats going on?
-Any solutions would be VERY helpful

Thank you

 

[MRfixit]

hi - go to http://www.automags.org/resource/level10/index.shtml this should answer any problems that you have.

 

[onutaka]

check your sear!

 

[Load SM5]

Try turning your velocity up until it cycles. You may have to turn it up a good bit. Idealy you'd like it to run on the medium spring to get the full anti-chop benefits.

 

[loz]

i am using the middle spring
with regulator output pressure of 900 p.s.i.
it tells you in the instructions to start with a certain size carrier
( i cant remember which one ) my marker leaked with that one,
but only when i pulled the trigger, so i went down one size.
it cured the leaking.
when you first set it up, you have to really crank up the velocity
adjuster on the back of the marker.
i have now done 7 boxes of paint without one single break.
i hope this helps.
loz