Leaking out of...Everywhere :S

[lemonadeX]

Hi guys,

Earlier on I aired up my PM5 and could hear a small leak out of the ASA elbow, so I took the (new) macroline off, cleaned and replaced it. That didn't solve the leak, and now it also leaks out of the pin hole on the underside of the ASA and also from the pinhole just above the elbow on the Hyper2 :s

I took the ASA apart (one of these), gave it a clean but no joy. I also took both elbows off and applied some new PTFE tape after cleaning the old stuff, and replaced the topmost o-ring on the bottom section of the Hyper2.

Completely clueless as to what I should do now, so any help would be much appreciated.

-Will

 

[lemonadeX]

Anybody got any ideas?

-Will

 

[PBNinja101]

if its from the pin hole, first guess is the o-ring on reg. try replacing it.

 

[KOHI]

how much air do you have?
My Pm some times leaks if there not enough pressure to seal every thing up

 

[lemonadeX]

Thanks for the ideas guys. Got it down to just 1 leak now, which is out the pinhole on the Hyper 2 Gonna take it apart and replace a couple of orings that the manual suggests.

KOHI, I've got about 1k of air left, which isn't a huge amount but should be enough to seal.

-Will

 

[Fly]

PM me your addy mate