Is this setup ok.

[rob_evanson]

I've currently got an Impulse running of a preset 3000psi system. So the rules of Impulse dictate that I must have a secondary reg to bring the pressure right down, so I've got a vert max flow. The thing is I like my marker to look good and I have got a Voodoo Foregrip which I want to use, but I can't because of my high input pressure.

My first option is a 4500psi maxflow then I can ditch the vert. (Mucho Expensive)

But then I can up with another idea. Can I get a preset 3000psi air system and wack it in the back of a 3000psi maxflow (usually for Co2) and turn the pressure down to what I want (no more than 200psi) and then plumb it into the foregrip. I'm still going through a secondary reg at the end of the day. Will this work or will I still blow my solenoid to shreads.

 

[L J]

not sure about blowing up, but alot most air system experience real drop off at low pressures like that, unless its an lp max flo...or have a ready all wrong?

 

[ericostani]

i think yes

because the preset is theoretically the same as co2. so it should work. and you can bling up yo marker, with ya voodoo foregrip

just make sure the pressure aint over 250psi output.

 

[TOOLE]

a co2 max flow inputs at 800psi and output from 100-200 psi, so it would be perfectly OK to do so, and there is no risk of blowing your 'noid, as the co2 max flow doesnt go over 200psi, and you really need 250-300psi to kill your 'noid.

hope it helps!!