IR3 SETTINGS nem6/cops?

[socom23]

IR3 SETTINGS nem6/cops?
Hi all have searched for this but nothing came up.

200? ir3
Nem 6
cops 2
mrof 15
mrof c15
Dwell 24
Pure energy 68/4500 ci
Egg II y board
blending paint.

Anyone got any usefull settings ideas? Or can improve on these?

Cheers

 

[Matt "Kenny" Pryce]

not sure about mem6
COPS 2 is the software version of your anti chop sensor
MROF is fine at 15
MROF C is fine at 15
Dwell is waaaay too high, use 14-16 - thats probably why your blending paint

 

[Scars]

if you intend using Cops. your MROF shouldnt be set any higher than what your loader is capable of. ie revi 12, egg 16ish

if not then i'd personally pull the rod out, use a z egg and set MROF to maximum

Dwell should be set to 14

should keep her singing

 

[Matski]

If your COPS sensor is working correctly, and your marker is setup correctly i.e hammer/bolt position correct then you should not chop with high mrof settings.

You need to set the Cmrof to the speed you want the rof to drop to when a ball is not detected. If your using a 12v revvy for example then you should set this at about 10-12bps. Your mrof can then be set at 20bps and you should be totally chop free and able to fire fast.

I suggest that you have an official Angel tech check your marker over, make sure the cops is working correctly. The sensor is sensitive to debris etc. You should not have to reduce your max rate of fire when COPS is activated, reduce it only when not using COPS.

 

[dr.strangelove]

I'd agree with Matski on your settings. MROF at 20, CMROF at whatever your loader feeds at. When a ball isn't detected, COPS slows the ROF down to what your CMROF is set to to give a ball time to fall into place, so if you set COPS up right (which NOBODY in the free world does, which is why COPS and Sensi have such a bad rap), there's no reason why you shouldn't set the MROF to it's limit. And 24 is WAYYYY high on your dwell. I had my IR3 at 12 (it came stock at 14). At 24, you'll be getting around 5 shots per 68ci 45000 psi fill You may want to invest in an A4 soft nose bolt too. That'll help with any rollback. Oh, and it' MEM, MEM6 not 'N'EM, but 'M'EM. Sorry to be nitpicky, but that was driving me nuts.

 

[Kitch]

MROF= Maximum Rate Of Fire with COPS off

See HERE

CMROF= COPS Maximum Rate Of Fire with COPS on

See HERE

To be honest when you read the manual the advise from WDP on both CMROF & MROF settings are exactly the same, basically dont set either higher than your hopper can feed.

I think your settings are a little on the wayward side at present, but I don't know why everyone thinks there must be some magical setting on the board somewhere that you can press a button and it takes of the 'chop' mode. Chances are it may well be a multitude of mechanical issues.

Best thing to do would be take it to a qualified tech and sit with them while they go through and check you gun over both the settings and your setup, that way you will have a greater understanding of how your gun operates and the correct settings to use.

 

[socom23]

Hey thanks to everyone who sorted this thread for me.
Im going to sort it out then prob let a tech look into it if it still not right.
Cheers all