Ir3 Grip Frame Screws

[qwikball]

Can anyone tell me the screw size for the drop forward on the bottom of the grip frame. Cheers

 

[Tom Allen]

10/32 unf, 1/2" to 3/4" long, would you like some of them.

 

[qwikball]

Tom yes mate how much? and where from?

 

[Tom Allen]

PM me you address and i'll send you a few.

 

[qwikball]

Thanks mate. PM'd you.

 

[dr.strangelove]

In case you're ever in a pinch, and some nice angel tech can't send you any, you can pick 'em up at a hardware store too. Stainless ones with those threads and lengths should only cost you about $.60

 

[qwikball]

Are you sure that the grip screws are not metric i.e M4 because all the other screws are?

 

[Mark]

Originally posted by qwikball
Are you sure that the grip screws are not metric i.e M4 because all the other screws are?

Those are the only NON metric threads on your particular Angel, there is an Imperial (standard) grub screw holding the trigger pin in on the Speed but the rest are metric. DO NOT use a metric bolt on the grip frame screw holes you will cut new threads or damage what is there already.

 

[Tom Allen]

Trust me the 2 screws that go in the very bottom of the grip frame are definately 10/32 unf. It's a standard size for all paintball markers, but as Mark says, all the other screws are metric, and the closest metric size to 10/32 unf is 5mm, but they have different pitches, and will not go in without damaging the thread. SO DON'T DO IT.....

 

[qwikball]

Tom i received the screws thanks alot mate