Ion T-board issue.

[mushk1n]

Hey all,

Just got a T-board and I had to fit a new clear hose on it due to the last one not being long enough, anyway I fit it and connected it all up and when I shoot everything the bolt moves with very little power and I can feel the majority of the air coming through where the handle is (if i take off the rubber). Anyone have any ideas what this is?

If i feed the paintballs into the feeder the bolt moves them but with not enough force to push it down the barrel :/

its as if the pressure is being lost and is probably going to be connected to the air that is coming out of the handle - where the battery is.

There is no other leaks, only when I shoot :S


Cheers all.

 

[lemonadeX]

Take out both frame screws and pull the body off the frame slightly (to expose the board and noid). Then air it up and you should easily be able to pinpoint the source of the leak. It's probably a hose not connected quite right or a banjo not screwed in fully or something.

-Will

 

[mushk1n]

well i tried to do that put found i couldnt press the switch in lol...

anyway i fixed the problem, just reset to default, I figured it must have been set to use with a QEV perhaps?

Well anyway I dont quite get how the air could have come down the handle, I looked on the bottom of the noid and I see a small hole the size of a pin - is this a vent or something? because that would explain a lot!


Thanks for your help

 

[mushk1n]

what are good settings to use with no QEV and stock bolt?

Cheers.

Josh

 

[arg1271]

probably the stock settings, dwell in the mid forties

 

[mushk1n]

well default by http://www.scenariodreams.com/manuals/ion_manual.htm is 34 for dwell and 15 ROF.. that doesnt make much sense cos on stock i had 45 and 0.... :S is the t-board setup different?

on the T-board does ROF = BPS?

 

[Oily]

The T board use ms(milli seconds) as apposed to 'blinks' on the stock board where you'll find 34ms =52 blinks

If you need more info try here:
http://www.warpig.com/paintball/technical/paintguns/smartparts/ion_calc/

 

[mushk1n]

The T board use ms(milli seconds) as apposed to 'blinks' on the stock board where you'll find 34ms =52 blinks

If you need more info try here:
http://www.warpig.com/paintball/technical/paintguns/smartparts/ion_calc/

genius!

Cheers mate!


oily, in reply to my first question tho, has the noid got venting abilities?

 

[Oily]

The solenoid vents at the bottom,yes.Here's a good pic:
http://www.zdspb.com/media/ion/solenoid_ping2.JPG

 

[John C]

Oops. Beaten to it.