invert mini chopping piant

[Zac marshall]

hey yestaday i used my mini for first time after it got serviced and it was chopping balls i thought mini were soft on paint, this also happend be for it got serviced does anyone have any advice as im concend about it as it stopping my rotor from working and it really p***ing me off

 

[WingNut]

Did you try another loader?

I would suggest that first to eliminate that possibility.

Cheers

Wingy...

 

[Zac marshall]

do you think it feeds to fast ???

 

[WingNut]

Not really...

Just always a good idea to check.

I would check the following, in the order they are shown:-

Detents (check for wear and check the springs. If you have spares, change them and THROW the old ones AWAY).
Loader (try a different one)
Paint (try a different brand/quality)

I'll be @ Bricket Wood this weekend (UKM South) and am happy to take a look for you if you are/can get there.

Cheers

Wingy...

 

[bojjob]

Also what are you shooting at? I had a mini ages ago, if I went anything above 12bps it killed paint.

Just a thought, but it could be just your rotor doing it... I had a rotor ages ago that literally chopped as it span. Generally bolt/barrel breaks don't stop a loader...

Try something more adjustable, like a Z2? I got one, not had a single break since on my demon.

 

[Liam92]

while it may have been serviced, was a fresh battery put in? could be that it is causing the eyes to not function properly.

 

[Zac marshall]

while it may have been serviced, was a fresh battery put in? could be that it is causing the eyes to not function properly.

i did but brand new battery in both gun and loader

 

[Liam92]

i did but brand new battery in both gun and loader

well if that's replaced, then check that your loader speed is not too high, and that your detents are working properly and are not worn down. Also when the gun is on, place your finger in the breach and make sure the eyes are working properly, since the wires could be partially damaged.

 

[Zac marshall]

can you turn down the rotor speed ???

 

[Liam92]

can you turn down the rotor speed ???

yes. if you take out the gear box thingy there is an adjuster screw that you use an allen key to turn that turns the torque up or down. so in practical terms it adjusts how harshly it spins i believe.