just taken out the solonoid and was just wondering if the gasket needs any grease on it to seal it when i put it back?
impulse
- Thread starter badboy
- Start date
You need to clean off all the old grease first then, apply a light/small amount of grease to the gasket.
Careful not to nick' it on anything, and to get the holes aligned up correctly. And when screwing the Solenoid back in, dont be too afraid to make sure the screws are in tight. Otherwise the seal between the solenoid and body will leak.
Careful not to nick' it on anything, and to get the holes aligned up correctly. And when screwing the Solenoid back in, dont be too afraid to make sure the screws are in tight. Otherwise the seal between the solenoid and body will leak.
done that and now when i fire the gun the bolt stays forward and the solonoid leaks.took it apart again and replaced gasket with a new one same problem.also checked poppet spring etc cant find problem?
Do you have a manual? There are also good instructions about cleaning the solenoid at http://www.kamworld.net/paintball/Solenoid_Cleaning.html . Theres summin to do with aligning the end cap properly when replaceing it otherwise it leaks.
Sorry I cant be of more help.
Sorry I cant be of more help.