Impulse was settings

[F3Z]

Ok so i decided its time to change the dwell setting for my new ram assembly, cept i cant get into programming mode (thru the trigger not the equalink)

I hold trigger and power for 1/2 second ten release both and i get the red light for a brief period of time (or if i pull and hold the trigger again for as long as i hold the trigger) but after both of these options it still follows with the normal operation of the green flashing light every second to represent its in eyemode one.

Neone got or had or even just used a WAS board ina impulse know what im doing wrong here!?!?

 

[BigG]

hey luke
in stead of letting both the trigger and the on/off go at the same time are you not supost to hold triger back - depress on/off = light turns green - release on/off - the release trigger
just a thought if your lettign the trigger off the switch before the on/off.

 

[BigG]

red light = low battery

change the battery over

 

[F3Z]

Hmm i think its a new battery but ill buy another tomoz to check. P.S when i say releasing on/off and trigger i did mean depress on/off = light turns green - release on/off - the release trigger.

 

[Skeet]

Depressed...turns green...pukes...asks you to hold hair out of way and rub her back..chics mate, all the same...

 

[Tom37]

hmm, a bit off topic here guys, but is the was board ramping yet??

 

[F3Z]

Not just yet, although on all new boards it does. The impulse software is due this week sometime. But dont keep ur hopes up