Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

impulse ram/hammer assemblys and valves

invid

invid

Tippmann UK
Nov 3, 2003
180
0
0
Glasgow
Visit site
looking to upgrade my imp internals, looking at the evil punch kit and evil valve

only review of evil valve i've read says it reduces volume harshly
anyone got any expericence with this valve

would evil punch kit and ND rip valve work well togther ?

i'm in need to techincal knowingness

currently on a more or less stock imp with tapeworm,delrin bolt and magno trigger
 
pgaglio

pgaglio

Used Car Salesman
May 2, 2003
260
0
0
Detroit/Motown, USA
Visit site
The Evil valve is designed to be run at higher input pressures than the New Designs valve. Unless you also plan to buy the Evil Respirator (LPR), I wouldn't get the valve.

I've used both the Evil valve and Resp. and compared them with the ND Valve and the ND LPR (a Jackhammer II) and I much prefered the New Designs parts. You can run at lower pressures with the ND and it was simply an easier to use combination of parts. However, if your goal is efficiency, then running the Evil combination at input pressures in the 200 psi range will definitely give you more shots per tank. All things considered, I'd buy the ND Valve and LPR.

Don't even consider the Evil bolt. I had a terrible experience with mine (won't bore you with details here) and would recommend the ND Equalizer bolt over the Evil any day of the week.

As far as the Punch kit goes, I've never owned one. However I do have the New Designs hammer assembly with a slick shot ram and stainless hammer. Works extremely well with the ND valve and LPR. Unfortunately, the reviews I've seen on the Punch are mixed at best. Some people have had problems with them, some report good results. Again, I'd buy ND.:)
 
invid

invid

Tippmann UK
Nov 3, 2003
180
0
0
Glasgow
Visit site
new designz is my preferred choice, but here in the uk i cant find any parts except the bolt, hammers and ram but i was looking for a complete assembly for drop in installation ease

my main goal is performance
 
S

Shep

New Member
Oct 30, 2003
206
0
0
Run a ndz silk shot ram,sp brass hammer,jackhammer ll lpr,& a strange delrin bolt,strange pull pin,
Have input at 180psi,lpr & approx 100psi dwell at 9 from bottom get pretty good efficiency would say around 1600 of a 4000 fill possibly more never realy checked as i only carry 6x140's & full egg,have never run out of air before paint even when only getting 2500 fills(1.5 bottle though)
P.s also have the ndz equalizer bolt & found the strange one to be more consistant over the chrono
 
T

TOOLE

Banned
Feb 27, 2003
1,115
0
61
DON'T buy the punch ram, they actualy make your impulse worse. The NDZ rams are far more effective :)
 
You must log in or register to reply here.
Top Bottom