impulse leaking

[joeyarmstrong]

friends impulse developed a leak.
seems to be comming for the solenoid (the rectangular block that sits in the upper part of the frame. this then connects to the board using a simple clip)

could this be something simple such as some dirt trapped or am i fearing the worse in thinking he could of over pressurized??

any ideas/ help, much appreciated.


cheers

 

[trenzo]

what pressure are you putting through it?

it may be the gasket- this is the piece of rubber which seals the solonoid to the gun. if you unscrew your solonoid and take it off the marker you should find it and then if you just put some lube on it and on the impy body, where it sat then pop it back on and screw the solonoid back on that may be all you need to do.

i had a simmilar problem and i turned out to be a chewed up o ring in the hammer assembly, so make sure it deffinatly is the solonoid that is leeking.

 

[joeyarmstrong]

cheers for that trenzo.
greatly appreciated.
ended up being a problem similar to the one youve described but its was a gasket inside on the soliniod that has slipped.



cheers mr trenzo, all working now

 

[trenzo]

anytime