imp adjustment ?

[badboy]

when changing internals of a stock vis imp to voodoo bolt, eclipse ss hammer ,voodoo bullet cap and adding a tapworm i,m assuming i will need to change the dwell setting or the input pressure on the vert max-flo to get 290fps
input psi set to 155 and dwell set to 11.5 which one should i adjust ?
double checked and its 6.5 does this make a difference
edited 12-05-03

 

[Rabies]

It depends if you're shooting too fast or too slow. If you need to increase the velocity, I'd say turn up the max flo a little, as 155psi is pretty low. If you're shooting too fast, leave the max flo where it is and reduce the dwell a little.

 

[badboy]

i don,t know what i,m shooting i have not fitted them yet .will arrive this week from eclipse.just after some advice before i fit them

 

[Rabies]

Well, firstly yes, you will probably have to adjust your maxflo and/or dwell after you change the parts. Keep the maxflo pressure in the region of 150-180psi and the dwell probably between 1/4 and 1/2 of the maximum setting, and you can't go far wrong.

 

[Half-Pint]

suck it and see.
there's no pre-determined adjustment to be made.
keep it all the same until the stuffs in, then if you find its runnin hot, cold, fast, slow adjust it accordingly.

Hp