ICD Bushy bolt pin replacement and other bits

[harmoosh]

This getting back into paintball is great fun, its amazing what you turn up in the loft!

I have discovered my B2K3 Bushmaster and remembered the reason I stopped using it.... the bolt pin top (the bit you grip to remove it) had sheared off. At the time it happened ICD were useless for getting bits shipped to the UK.

My question is, does anybody know if its still possible to get parts for such an old marker? I think the Impulse used to use the same shape / size pin, are these still available?

The other problem I recall with the Bushy was the flaky board supplied as stock. There wasnt any way of configuring it and as such it suffered from severe bounce, is it still possible to get a Chaos board or similar which has slightly more features than nought?

As always, any help is greatly appreciated.

 

[Dark Stranger]

Got a delrin impulse bolt & pin you can have for postage cost?

 

[rayko]

You can still get the VaporWorks board but you would then need to fork out for the interface cable and software. In all honesty - the BM2K is a doodoo.

 

[robof9]

i have a vapor board , and defo have pin. just gotta find data link cable....

also have icd freak back, unless i chucked it, and an ebay valve. also have gauge tool and other bits of kit.

pm me what you need and i will see if i have it

rob

ps just check how many pins you have on ure harness

 

[FirebirD]

I think the shocktech bolt with pin might fit, but im not sure.

 

[harmoosh]

Thanks for the responses folks, I will PM you shortly.

You can still get the VaporWorks board but you would then need to fork out for the interface cable and software. In all honesty - the BM2K is a doodoo.

The prices have been slashed on the vaporworks/paintball trader site so I may order them if nobody here can help. I already have freak backs etc for the marker so would much rather get it up and running than sat as a paper weight.