I need help with my regulator!!

[morepho87]

I just purchased an ergo regulator. Once I hooked it up, it started leaking out the bottom, where the adjustment screw is. I don't know what the problem is, but since it's used, I wanted to take it apart and rebuild it. I'm not quite sure how to disassemble it, plus the screw on the side is extremely difficult to loosen. I don't want to break anything, so before I strapped it on the vice, and used some extra torque, I wanted to run it by everyone. Any suggestions would be greatly appreciated. Thanks in advance.

Julio

 

[elrikos]

i'm going to assume that the "screw in the side" that your talking about is in fact a little plug with a hex cut into it? if so then thats an inlet thats been blocked off. unless your reg is leaking past this plug then don't bother taking it out. it will be extremely tight cos it will have been threadlocked in and you'll waste a whole load of time removing it. better to find some decent instructions and disassemble it according to those. you don't want to put something back in the wrong way up or something! if you can't find instructions then take it to your paintball shop and get them to take a look at it.
hope that saves you a bit of time
rich

 

[morepho87]

That's the problem though, I can't find any good instructions on how to disassemble it. I've searched everywhere on the internet. Does anyone know where I can find this information.

J