How to eblade an autococker trilogy
Kit needed
1/ a sticky pad
2/ two Zip ties
3/ eblade Frame
Stick the sticky pad to the LPR (Please note the sticky pad was the type you get for sticking a car mirror to the screen ) Now stick the eblade 3way to the LPR. At this point you may need to use some new Low pressure hosing or swap around the old hosing which is on the gat as some of them are a bit short.
Next run the 3way wire around the last of the old 3way fittings this helps to keep the wire out of the way, next bring up the frame to the bottom of the marker and run the 3way wire a long the frame and then attach the frame to the marker.
Now cocker the marker to check to see if the lug will catch on the sear if it does not then you will need to set the hammer lug just as you would if it was any other cocker.
The last thing we need to do is to put the zip ties around the 3way and the LPR this is just to help to keep it on the marker.
Kit needed
1/ a sticky pad
2/ two Zip ties
3/ eblade Frame
Stick the sticky pad to the LPR (Please note the sticky pad was the type you get for sticking a car mirror to the screen ) Now stick the eblade 3way to the LPR. At this point you may need to use some new Low pressure hosing or swap around the old hosing which is on the gat as some of them are a bit short.
Next run the 3way wire around the last of the old 3way fittings this helps to keep the wire out of the way, next bring up the frame to the bottom of the marker and run the 3way wire a long the frame and then attach the frame to the marker.
Now cocker the marker to check to see if the lug will catch on the sear if it does not then you will need to set the hammer lug just as you would if it was any other cocker.
The last thing we need to do is to put the zip ties around the 3way and the LPR this is just to help to keep it on the marker.
.
