hi having problems with an eclipse marker

[quade99]

hi the marker i have is an eclipse evolution im not sure of the age but its in very good condition firstly can i use co2? also is it automatic it has a digital display and three buttons on the handle in the mode menu it shows semi and clas what is clas? also when i pull the trigger it sticks on can you help me please and be patiant with me please im quite new too paintballing thanks

 

[nat]

1/ If it were me i would only use compressed air not co2, being an electronic gun.
2/classic mode is when the trigger is held back,the bolt will stay back also simulating a mechanical marker,(you have an electronic eblade marker).
3/ The trigger may need tobe adjusted (has a magnetic return)adjust the grub-screw at the top of the trigger blade (the one nearest the front of the gun,screw in to increase.also check the trigger pivot pin,(clean & lubricate!).

Woody.

 

[quade99]

thanks that helps alot is the marker automatic aswell?

 

[nat]

It should be semi-auto only (unless you have a ramping/3 shot burst board installed) i think,1 shot every trigger pull,but will shoot ropes if you walk the trigger with 2 fingers!

Woody.

 

[spreadz07]

I would say your trigger pin needs cleaning.
You need to take it out and sand it down with a piece of sandpaper or emery board. Once clean put it back in and it shouldnt stick.

Go here and download the Eclipse Blade manual (right at the bottom in text on the left hand side)

http://www.planeteclipse.com/site/eDownloads.asp

Will tell you all you need to know
Nige

Ps. A c0cker will work on air and co2, but with a electonic trigger you will freeze your gun down when firing fast if you use co2

 

[quade99]

thanks alot ive sorted the trigger now, it needed a good clean and that manual will realy come in handy thankyou. just one more thing, i screwed in a co2 bottle to check it worked but the pressure wasnt pulling the cocking arm all the way back it might have been the trigger but im not sure, could it be anything else. im not going to try it again untill i get an air bottle

 

[Gee Tee]

The front low pressure regulator may need adjustment, but make sure you have a full bottle before setting it. If it still won't c0ck on a full tank gradually increase LP setting until it does, and the give it another 1/8 of a turn. Don't over pressurise or you risk bursting a hose or damaging solenoid.

This is a great site for Eblade tips....

http://www.moodypb.com/cart/