help needed

[Omar K]

hi guys, ive recently been having troubles with my trigger as it was in the wrong position and the gun wasn't cocking properly... i put my co2 in to test if the gun was going to fire and i got a mix of perfect firing and the million recocking shots noise that you get when you are low on gas (full tank at the moment) i fired maybe 150 shots with a 20 oz co2 tank and about 30% were the recocking shots.. i then noticed a hissing sound coming from the gun so i took the tank off and tested to see if their was air left... there was, i then decided to try again but it seemed that there was no air left as the gun was not even attempting to recock it felt like bolt action though there was no hissing... took the tank out and tested for air again.. some but not loads, and tried again... as soon as i got the tank on the air started leaking out the barrell slowly (i was later informed by google this can happen when the air is low?) took the taqnk out again to test for air and it was empty.

do i have a leak or could the gun trying to recock itself have used the gas?

 

[Omar K]

(bt-4 slice with e-grip) any help appreciated

 

[gommie404]

mate,, dont know how to tell you this,,co2 has no pressure this time of year...if its cold dont use co2,,,

in fact dont use co2 at all,,time to step up to air,,, your allways have problems with co2,, its a hard gas to understand,,
where as air is the same nearly all the time,,,

 

[Omar K]

thank you

 

[Monkeyboi]

It could be the oring on the hammer if there is even the smallest nik in it it can't build up enough pressure to cock it try changing it

 

[famsuks3]

Try adjusting the sear I have had the same with my ironhorse.

 

[darkfirepheonix]

ok i have seen this issue with the new bt4 slice. this is actually caused by the power tube. i have stripped the power tube down and drilled a slightly bigger hole where the sear seals the air. think i used a 2.7mm drill piece. i have herd kee is thinking if revising the power tube on the slice to solve this issue.