HELP DYE NT, not sure really.......

[Connor Nourse]

so i dropped my DYE NT11 while cleaning it and something fell out and now i cant screw it back in again......

apologies for bad picture as it was taken with my phone

please help!

 

[tricky m]

There should be a ball bearing and a pin. If I remember correctly. Remove the screw again. Inside the frame is a hole. See what comes out when turned upside down. if you have both. Put pin in first. Then ball bearing. Hold up right. Then try putting screw back in. Will be easier with airport off. So you can check pin is in correctly.

 

[tricky m]

Just looked on dye parts. It is just a pin with a dome head on one side. This needs to be all the down the vertical hole before screw can go back in.

Hope this helps.