halo troubles

[Ryan(pb alexandria)]

When I stick my halo on my shocker it keep jamming

Basically it will fire then the jam sequence will go on etc. The eyes are clean and the halo does stop when u stick ur finger up the hole (aheam).

It is heavily sanded but i now got a qlock so when i stick the hopper in it can move alot before i tighten it. Surely if its set 1-2mm off centre thats not gona stop the ball stack?

any ideas/questions
?

Cheers guys.

Ryan

 

[MrPink]

Assuming that your paint isn't the cause (no mis-shaped or over-sized balls), then it's either your anti-jam beads and spring aren't there/broken, your batteries are flat (this causes all kinds of strange problems, even without the low-battery indicator coming on) or your eyes are just plain dying.

 

[Ryan(pb alexandria)]

how would i know if the eyes are completely gone..Could be the batteries. Ill check em.

Beads and spring are fine.

Ide use my eggy but its just so ugly on my lovely shockingly fast shocker.

 

[MrPink]

Unless you have a multi-meter, the only way of checking your eyes is to replace them and see if the problem goes away.

 

[Skeet]

Apparently, there is a screw for adjusting teh eyes on a shocker..tho it would seem it is teh halo eyes that may be the problem. Make sure you clean the back of teh eyes as well as the front.

 

[Ryan(pb alexandria)]

yeh its my halo defo not my marker.

I changed the batteries shall try tomorow, gona get a new set off eyes off a team mate see if that works.

Am pretty sure its a ball jam in the loader tho and the springs and beads are fine. This sucks..