Right, I've got a couple of these Halo Turbo kits for sale. These are very similar and work in the same way as the Shocktech Speed wheel, but these are made from white delrin. They slip onto the shaft of your motor where the band attatches effectively increasing the diameter of the shaft.
Claimed to increase the speed of the loader to approx 133% of the stock speed. Which isn't too shabby.
£9 to your door. I accept paypal(+50p), cheque and banktransfer.
---------------------------------------------------------------------
Installation Instructions
I takes about 7-8 mins depending on how good you are at taking apart a Halo.
TOOLS REQUIRED:
STEP-1
STEP-2
STEP-3
STEP-4
RESULTS:
STEP-5
Claimed to increase the speed of the loader to approx 133% of the stock speed. Which isn't too shabby.
£9 to your door. I accept paypal(+50p), cheque and banktransfer.
---------------------------------------------------------------------
Installation Instructions
I takes about 7-8 mins depending on how good you are at taking apart a Halo.
TOOLS REQUIRED:
- Hammer
- Screw Driver
STEP-1
- Remove your hopper shells.
STEP-2
- Pull your cone assembly out, and remove the 3 screws in the back so you can access the motor.
- You should have the motor, gear and band
STEP-3
- Place the speed wheel GROOVE side DOWN on a table, and place the motor over top.
STEP-4
- Tap the motor where indicated with the hammer, until the brass fitting is all the way in (it should be tight, its meant to be like that so it wont slip)
RESULTS:
STEP-5
- Re-assemble Halo
