Halo Button help

[Ryder]

Hey,

just got a new z board for halo cept it has a long button and my stock was short and hence it wont fit. how do i solve this?

Ryder

 

[WingNut]

Remove the rubber button..

Let the longer one stick through.

 

[Ryder]

yeah i was thinking of that but wont paint and mud and general crap be able to get in and ruin the board?

Ryder

 

[Tom Allen]

The button is plastic, so cut it down.

 

[manike]

Cutting the plastic button on the board is risky. It's very easy to break it off the board.

A better option is to cut the rubber button on the back board.

 

[Ryder]

ok its all fine now cept for one thing. wen i switch the halo on the green light sort of dims a bit. then it starts flashing red green quiklyy. ive cleaned it all so its no blocked nd stuff. what is rong. batteries?

Ryder.

 

[fuzzy juzzy]

new bateries needed

 

[Gyroscope]

Originally posted by Ryder
yeah i was thinking of that but wont paint and mud and general crap be able to get in and ruin the board?

Ryder

You could put a sticker on the hole. Or electrical tape if you don't advertise for free.

 

[stark]

Originally posted by manike
Cutting the plastic button on the board is risky. It's very easy to break it off the board.

Yeah that happened to me. I cut some macroline to replace the button and fixed it in with duct tape.

 

[DOA Robbo]

if changing the batteries doesn't stop the flashing light then it's a pinched wire (took me a while to figure that one and a few sets of batteries )