Hey guys got an ego
Want to put a gauge on the oops (for reg pressure) where the allen key grub screw is. Is this possible?
Want to put a gauge on the oops (for reg pressure) where the allen key grub screw is. Is this possible?
Gauge on an Eclipse OOPS
- Thread starter BOLDY
- Start date
Don't see as it would cause a problem, would give you the output pressure of your pre-set reg.
Is that what you are after, coz it should always be the same.
Laters
Is that what you are after, coz it should always be the same.
Laters
There isnt realy any point...if its a prest then, it will be putting out one of two pressures, Hi 850 or Low 450.
The only place you might want a gauge is on the FRM for reading teh output of teh Reg.
The only place you might want a gauge is on the FRM for reading teh output of teh Reg.
