G6R cycling issues

[emisnug]

So, bought a G6r fairly recently - have had nothing but troubles since I bought it. It was recently serviced by Progress Paintball (thumbs up!) and had a new noid fitted - which worked perfectly. (He sent me a video of it working -

)

However. When I screw my bottle in, I get nothing. A small puff of air when the noid cycles, but that's it.

HPR is set at 200
LPR is at 100

I don't really want to push it higher in case I break it, but the reg is a Pro V2 and (according to the shim stack diagram) should be outputting 450PSI. I know the bottle works on DM's and Geo's, and as such am at a bit of a loss as to what to do.

I've tried resetting the board, put a brand new Energy Paintball battery in - all the normal troubleshooting steps. James (I've forgotten his username on here, but he's on holiday at the moment) reckons it's the bottle at fault.

Help? Please?

 

[raxable]

try another bottle if you can.

I have a G6R and have experienced the same or a similar issue.
It was down to the Pro V2 in the end as the guns asa pin wasn't pushing the bottles reg pin/ball open enough.

 

[cheyenne]

i have seen this to and it was the pro v2 reg [ as above ]

 

[emisnug]

Finally managed to wrangle a bottle to test with. It's the Pro V2, which is a pain because I only bought it in May. What are bottles going for these days?

 

[raxable]

keep the bottle and just get a new reg for it.

http://www.lips-paintball.com/acatalog/Ninja-SLP-Regulator-4500psi-1400.html#.U_OcoPldXSg

 

[WildWayz]

Glad it is sorted out and the issue identified