Fitting Inteli Feed To Angel Ir3

[VENOM]

How do i fit the intelifeed from my angel to my red revvy..... do i bypass the x-board and go straight to the red and the two white wires to the motr or what can someone please tell me where to cut an where to soldur...as far as i know the intelifeed in the gun is set up an ive ran the test on the 14 way valve wiv a pencil ha ha any help would be greatly recieved.........fed up of forkin out on bloody hopper batterys.

 

[John C]

Take out the board and battery clip and dump it.

Open the gearbox, de-solder the existing wires from the motor and solder your two intelifeed wires in their place.

If you have a vortex paddle or similar then you need to test the motor before you solder to make sure the motor is spinning the right way.
If you have the stock paddle then it doesnt matter which way the motor spins.

 

[thekid]

can u use an Halo b or Egg2 with the intelifeed system??

 

[thekid]

sorry,4got....on a Angel 4!!

should be the same...isnt it?

 

[dr.strangelove]

You can't use a HALO, and I guess there's some way to do it to the Egg, but it sounds like more trouble than it's worth.

 

[John C]

Since you have to keep the batteries, an intelifeed egg is just a cheaper alternative to a Z-board egg.

Also on the angel 4 there is less room to put the connectors under the sight rail. Im sure it can be fitted, but it would be alot of work.

 

[Mark]

Here is how to do it with a egg..together with nice pretty pictures

Intellifeed an EVo2