Evo Z-Board installation problem

[WingNut]

Hi purchased a used EVO II from the classifieds section..

I've gone to fit a Z-Board to it and I'm having trouble getting the wires to reach the board without being pinched by the shells.

On the motor, it has a sticker with VL REVOLUTION on it.... thought that a bit odd as its an Evlution....

Please tell me I havn't been stiched up here.....!!!!!!!!

Again...............

 

[Mario]

Were the wires being pinched when you bought the two halfs together? if so theres a very small gap by the motor you've got to squeeze them into. the design is crap i must say....

 

[WingNut]

Don't worry Mario, it wasn't the one I bought off you. It's another.

I'll look for the small hole but I still dont think it will reach..........

Thanks.....

 

[Mario]

Originally posted by WingNut
Don't worry Mario, it wasn't the one I bought off you. It's another.

I'll look for the small hole but I still dont think it will reach..........

i know mate, i only sell quality less of a hole, more of a gap....

there's a joke in there somewhere...

 

[WingNut]

Sorted the installation problem, just removed the bottom of the motor and poked the wires through the other side............

Just this REVOLUTION stick bothers me now.... in an Evlution.......

Strange........

 

[DangerousBrian]

the baord on a revie is totaly different, so if this one has gone in ok, then its a eggy board

 

[Mario]

Originally posted by WingNut
On the motor, it has a sticker with VL REVOLUTION on it....

ahem

 

[Skeet]

Revy's and Eggy's share the same motor...it may be that the Egg is secondhand, and the previous owner replaced a blown motor with one from a Revy.

 

[Ghost Stalker]

eggys all have the revolution motors,just sorta different gizmo's inside. You aint been stitched up m8, and yeah the wires are a bitch