etha inconcistant chrono readings

[trevor hook]

hi guys i`v just replaced my old poppet for the spring less one,cleaned and greased all o-rings ect after putting it all back together and test firing the chrono readings were going anywhere from 264 to 305 but before i changed it the readings were usually 294 to 297 any help please still a bit of newbie at this

 

[Magic Rat]

Not had an Etha ,but take it apart again check everything is correctly together.
Lube it lightly( plenty Jack Woods videos on how to grease)
Fit new battery,then run in for a few pods ,if no luck then contact Rob @ planet eclipse.
customerservice@planeteclipse.com
He will sort you out great guy.
Lots of ETHA info here.
http://www.pbnation.com/forumdisplay.php?f=862

 

[did243]

hi guys i`v just replaced my old poppet for the spring less one,cleaned and greased all o-rings ect after putting it all back together and test firing the chrono readings were going anywhere from 264 to 305 but before i changed it the readings were usually 294 to 297 any help please still a bit of newbie at this

bad paint? bad bore match? dwell changed? not enough lube. too much lube, alot of variables that can play with FPS

 

[StewartW]

Check and replace your #12 Oring on the valve joiner and give that a bash.

 

[trevor hook]

cheers for comments guys going to try again tomorrow using all tips given.i`ll let you know how i get on.

 

[trevor hook]

hi guys i took the etha apart again re-cleaned and put a little less grease on, was a bit to much on before, all o-rings ok.i took it out to test with a new batch of paint and put 2 pods through it, checked it over the chrono and sorted all in the 280s so cheer guys. slowly learning as i go haha.