Etek oops leak

[wychwood]

Hi,

Recently I got into the world of using an Etek, unfortunately It was purchased 2nd hand without an LPR so I borrowed a mates and it worked fine for a few tournaments,

Recently I bought a new LPR screwed that into position and now when I gas it up a big leak starts from the front hole on the bottom of the oops.

Ive tried different settings on the LPR, and have it flush with the cap, ive also removed the LPR piston and seat and cleaned and oiled the O-rings. No luck.

So now i'm stuck, any suggestions?

cheers

 

[Niall W]

Remove the oops pin and lube the o - ring with dow33

 

[wychwood]

Thanks for the quick relpy, but no cigar my friend, still leaking!

 

[Nosvartu]

Can you send me a picture because i think this happend 2 mine so if you send me a picture ill be able to tell you if it was same as mine or not.

Either post here or my email its fine
Mike-drane@hotmail.co.uk

 

[wychwood]

Ah ok, I don't have anything to take a photo with unfortunately, erm, what did you do to sort the problem out?

cheers!

 

[Devrij]

As suggested, remove the oops pin fully and replace the orings on it, and relube with dow 33. That's the only possible cause for a leak from that part of your marker. The symptoms of an LPR problem tend to manifest in the form of a solenoid leak or damaged rammer orings.