etek 3 not firing

[JameC]

Hi basically i was takeing the board out of the grip frame it was all fine i plugged everything back in than when i went to dry fire the marker it would not fire with the eyes on and off and when i turned the air off and fired it with the eyes off the solenoid wasnt clicking i checked to see if everything was all plugged again and it wasand i havent touch the solonoid since i got the marker

 

[StewartW]

Are all the cables seated properly?
None of them are getting pinched?

 

[desponge]

sounds daft........fresh battery?

 

[JameC]

yeh just put a fresh on in and all the the wires look to be fine

 

[MeDiC]

You may need to re-adjust your trigger to make sure it is contacting the micro-switch...

 

[JameC]

when i pull the trigger it defiantly hits it you can see when you take the grips off

You may need to re-adjust your trigger to make sure it is contacting the micro-switch...

 

[StewartW]

It is

when i pull the trigger it defiantly hits it you can see when you take the grips off

Is it de-activating though? Maybe the trigger is in too close and permently depressing the switch?

 

[automag]

Where are you in the UK if you are local to me I am more than happy to have a look at it for you. I am a few miles from junction 10 of the A1(m)