Etek 2 troubles

[uther313]

hi guys one of my team mates has a etek 2(i have it at the mo to try and sort it out) and there is a problem with it. i have cleaned and striped the Hpr and the Lpr along with the rammer the rammer housing and the noid reset the board to factory setting and changed the battery and the problem is still the same.
when the gun is aired up it shoots and sounds fine as sone as you try to put balls through it they just roll out of the barrel the first shot is the worst but even with the HPR alll the way up the marker still only fires about 150bps if that. does anyone no anything that would fix it.
cheers

 

[Luke H]

I had this problem with mine too Uther, one cause could be that the rammer housing has been put in the wrong way, this is what I was told to do too fix it....

take the gripframe off and unscrew your inline reg. use an allen key to remove the screw inside where the reg screws in, and also remove the screw about halfway along which sits flush with the body of the gun. this will let you slide the LPR, poppet etc out of the body. take out the black rammer housing and look for the small hole near the front and make sure its orientated up, as this is what allows the air to move through the bolt. stick it all back together and try it again. (basically the hole the screw will go into on the rammer housing should just be a little indent not an actual hole: this is the one you want facing up)

 

[Impulse raider]

As mentioned above, unscrew the fixing bolt from within the NPR reg and turn the lpr housing around 180 degrees, also check the rammer housing is also the correct way in..

 

[uther313]

ok guys ill double check but in sure they are the right way as the problem started one day and the lad hadnt taken it apart. but ill check all thats said and post back up