ego 10

[brad93]

im having trouble with my ego10, where the paintballs arent being fed into the breach properly and are being obstructed by the bolt where it just or so cuts into were the balls are fed, this is withought a supply of air if tht makes a difference, and the bolt pin has been pushed all the way down. thanks

 

[cowface]

the bolt pin has not been placed into the groove of the zik kit thus resulting in the bolt sitting slightly forward.

 

[brad93]

sorry what groove?

 

[cowface]

take your bolt out, look at the zik kit, you will see a groove/slot for the bolt pin to be pushed into.

 

[Mikey D]

When your bolt is in the right position (ie ready for a paintball) you will see a small 'dot' on the top of the bolt just before it slides into the body. If it's not, the bolt isn't quite installed correctly

 

[brad93]

i can see the dot on top. and the pin is on the zick kit slot. but it still abit too far forward
http://imageshack.us/photo/my-images/703/110614113949.jpg/
http://imageshack.us/photo/my-images/268/110614120739.jpg/

 

[NitroBall]

im having trouble with my ego10, where the paintballs arent being fed into the breach properly and are being obstructed by the bolt where it just or so cuts into were the balls are fed, this is withought a supply of air if tht makes a difference, and the bolt pin has been pushed all the way down. thanks

When you air up your marker, the pressure from the LPR/noid will push the rammer and bolt back.
or
you can just push the bolt back freely when the marker is not pressurised.

 

[Mikey D]

i can see the dot on top. and the pin is on the zick kit slot. but it still abit too far forward
http://imageshack.us/photo/my-images/703/110614113949.jpg/
http://imageshack.us/photo/my-images/268/110614120739.jpg/

I can't quite see on my phone but if the hole is in the right place on the top like it looks, all that is confusing you is the face of the bolt has a chamfer on it. It's not a flat face like on the older egos

 

[essx]

Looks how it should to me!!!
Change your detents just to rule any problem out!!