Why is my ego 06 leaking out from the hole half way up the HPR? I cant figure it out. I have been told it was the lack of a seal on top of the piston, but I just bought a spares kit and there isnt a seal on top of this piston either.
ego 06 leak
- Thread starter sumo89
- Start date
could be the oring gone where the 2 halfs meet, if you are at the masters this weekend bring it over or the oring on the brass piston in the inline
thanks codiak, thats all i needed to hear.
dan i wont be at the masters, im in edinburgh and its a bit far. Thanks for the offer though.
dan i wont be at the masters, im in edinburgh and its a bit far. Thanks for the offer though.
this is not the same piston just using as an example, but have a look at the top, yours should be sealed in the same way with a black plastic cap.
http://bumppaintball.com/product/markerParts/etekImages/bumpEGOlpr001.jpg
http://bumppaintball.com/product/markerParts/etekImages/bumpEGOlpr001.jpg
yeah i thought so. But couldnt find any information on whether that was the actual problem or not. Thanks.
If the leak is the vent hole on the side of the inline top the problem is the number 10 o-ring on the inline bottom. Kinda hard to explain but if you split the reg look inside the inline bottom you will see a number 10 o-ring replace this and relube it job done. If this does'nt work should do 99.9% of the time then replace the 15nbr90 on the inline piston.