Egg2 Problem and E1

[shaunyboy]

Right my prob with the egg is that i have just put new batteries in it and the low battery light comes on yet i tested the batteries and the are fine, i think its just a fault connection somewhere??
Any ideas??

The prob with my E1 is that i have cleaned the eyes and got a good paint to barrel match but when i start firing above 8 bps it starts to burst paint but i have just changed the colour of paint i was firing and i think it is some to do with the eyes not picking up the colour cause it wasnt bursting wth the last colour.Yet again any ides????
Cheers Shaun

 

[jahlad]

the egg.....i seem to remember reading something similar not long ago, was something to do with something far to electronic for me to fathom but wasnt doing any harm

the e1.... have you changed any settings? put it in factory fast and try it again. if you have no joy there ill try to diagnose a little more accuratly.
90% of the probs ive seen with them are people changing settings for no reason, factory fast will shoot as fast as your fingers will move.

 

[Equinox]

With the egg..

(although ive never had this problem..)

Check its internals for a pinched wire..

i remember reading somewhere that this can cause a simmilar problem.
(im guessing, but a damaged wire does reduce current flow and could make your egg think its running low..)

 

[Skeet]

Yeah...was my Eggy I just acquired, Ive got to check the wiring on it.

E1...yeah, stick it in Fact FST, make sure your CDEL is set to 006 if you have a 44Ram and QEV's....if its still doing it, you may need to check your bolt is set correctly.

Could well be that the eye wasnt seeing teh paint...or at least teh difference between the bolt, teh breech and teh paint.

When you clean teh Eye, clean teh terminals on teh back as well...might have to raise teh sensitivity when using dark paint.

 

[Geraint]

i've had a few probs with my e1 too, balls splittin in the loader and double balling...but only sometimes. i can go for 20-30mins shotin before it starts and afta that it stops too.i think i gona pop in to eclipse and let em fiddle with settings...aint got a clue with settings myself.

 

[jahlad]

Originally posted by Geraint
i've had a few probs with my e1 too, balls splittin in the loader and double balling...but only sometimes. i can go for 20-30mins shotin before it starts and afta that it stops too.i think i gona pop in to eclipse and let em fiddle with settings...aint got a clue with settings myself.

that sounds like eather a dodgy loader or crappy paint to be honest....as for settings just put it in factory fast and leave it like that and see if that helps

also a new battery cures a lot of eblade probs

 

[shaunyboy]

hi guys thanks for the replies. I hear peaople say factory fast alot and the settings like CDEL etc.. but what are they and how do i change them.
Cheers Shaun

 

[ladyboy]

just open right side of grip frame and hold down the red button till you get the menu. use the up and down buttons to change from factory whatever to fast and leave it!! on mess with the eye sensitivity if you have the eblade manual to hand and you have understood the instructions. With cockers 90% of marker probs are from the owner messing with bits they dont fully understand. Its been a while since ive had a cocker bt skeet is the man who knows or dangerous brian from belsales.

 

[ladyboy]

sorry if above post isnt that detailed its just been ages since ive used an eblade1

 

[Geraint]

thanx for suggestions, ive tried new batteries and diff loaders and it still sometimes does the double balling, i'll try the factory fasty settin ya mention see if that does the trick. cheers again