Eclipse E1 - Breech Sensor

[vicker777]

Got a E1 Autococker. Manual says that when the bolt is open the reading should be in the 200's and almost 0 when closed. Mine is 203 when bolt is closed and 238 when bolt is open...setup is 128

and the result is that I am chopping balls when fireing to quickly, checked the ball dent and that is fine. Already cleaned the sensor

Any ideas?

 

[Skeet]

Black delrin bolt then...should be nearer 0 with a ball in the breech, usually around 11...

 

[vicker777]

thats exactly it, any ideas? Still chopping

 

[Skeet]

Try upping yopur EMPD or BALD by 1, try them individually etc...

Actually...before you do that...try turning your LPR down, as you might be fracturing teh paint..also...is it actually chopping, or breaking in teh breach?

 

[vicker777]

hmmm difficult to say wether it is breaking in the breech or chopping. What basically happens is a ball breaks and then the bolt gets jamed on paint cell near the breech.

 

[Skeet]

How long has it been doing it?
Set it to Classic mode, and make sure teh bolt clears teh Breach..should only be around 1mm visible, ehen viewed down teh feedneck...

 

[vicker777]

just started recently, used it with Physco paint and it was great not a single break. Then last week at YPC got a break every 300 balls , using RPS premuim.

Mode is currently auto will switch to classic.

What should I try first:

LPR
EMPD / BALD
Classic

thanks for all the help

 

[Skeet]

Check bolt clearence in Classic mode first.
Also check that your barrel bore, is tight enough for the paint, combined with the detente...make sure you arent using Eclipse Fang ADB, with a HALO...nasty...

Check you LPR, just back it out then re set it, till it uses as little pressure as possible, to effectively cock the gun...

If you have QEV's on a 44/nexus ram, make sure CDEL is 006...

 

[vicker777]

ok mate here is my current setup

Timing:

SON = 004
CDEL = 003
CON = 65
CTO = 255
COFF = 028

Filter:
BALD = 001
EMPD = 002
TPUL = 004
TREL = 020

Marker has got full nexus internals, derlin bolt & QEV's. Don't know about the ram but think it is a 44/nexus. Using a 12v Revvi and 4500 preset pro toyz reg.

About to try classic mode first.

Thanks for all the help!

 

[Skeet]

Thats Factory fast...Change your CDEL to 006 asap...the Ram and QEV's, work so fast, that the ram will begin to operate, before the gun has finished the previous cycle