Eclipse 300psi Gauge

[yngndrw]

Hi guys (and girls),

Well I have a Smart Parts ION which had a broken gauge, so I replaced it with an eclipse one.

It has been running around 160-180psi, so nowhere near the 300psi.

It has only been used for about 1000 rounds, and a bit of dryfiring.

Just now, the needle on it has broken, and no remains in a verticle position, facing down.

I'm just wondering if this is a faulty guage or could I have done something to break it ?

Cheers,
-Andrew.

 

[Tom Allen]

Over pressure is the most common cause of failure.

 

[yngndrw]

Well it's a 300psi guage and it was set to run about 180psi, unless I turned on my air supply too quick but I doubt I did.

 

[spreadz07]

If you havent over pressurized it, cotact planet and see what they say. I know for a fact if its faulty they will replace it for you.
give tom a bell at planet.
nige

 

[yngndrw]

Well I'm heading up there in a couple of weeks to get some playing pants, so I'll take it in when I go.

Cheers.